To install an electric fence

!±8± To install an electric fence

The attempt of livestock on your property and destructive wild animals is the old problem of farmers and ranchers.

Suburban must realize that it may mean fighting suburb urbanization of rural life with the rebels, which was once the campaign. This article goes over the basics of building an electric fence to help the animals from the property.

It is not too difficult task for the do-it-yourself, but you will have to do with power, sogreat caution should be taken into consideration in this project. The instructions in this article applies to farmers, breeders or owners of houses and apartments.

Tools and materials:

Hammer
Screwdrivers
Stripping
Pliers
Electric fence control
System Grounding
Electric fences
10-14 gauge insulated wire with 20,000 volts
Voltage testers
Insulation Wrap
Post Auger

Safety and warnings

Make sure your post warning signs on electricalFence. If you have a fence that will run on DC or battery operation, not connected to a type of alternating current supply or house. The barbed wire is not a candidate for electric fences. You do not want to put an animal or a person in beards always a constant current pulse. To recharge the battery on a DC-powered fence, be sure to disconnect the battery from the controller before the barrier. Do not connect other devices to the circuit that electric fence. If lightning strikes the barrier,You may receive the increase from other connected devices. If you want to make changes to rent in consultation with the manufacturer, then you are a professional, if the manufacturer recommends it. Read your warranty. There is a reason why there are some limitations associated with the warranty. And 'so that the correct and safe way to keep everyone on the fence. Make the instructions to unlock the fence controller in an emergency and ensure that allAffected to understand instructions. Read the safety instructions in the manual, and review regularly.

Step 1 - Find a safe place for the fence controller

It 'important that the owners of the electric fence is installed somewhere to shelter from the weather. If none is available, then you need to install any kind of accommodation for the installer. Follow the manufacturer's instructions for installing the controller. Connect the controller to fencingfully installed.

Step 2 - Installing the system ground

Install the auction of land within 20 meters of fence controller. The tail should be two meters or longer and are installed in the ground. Perform a 10-14 Cable Ground Gage from the controller to the grounding rod. Secure it, the rod with a clamp. Check the manual to get the bars on the need for additional grounding.

Step 3 - Installing fences

The bolt can be installed 25-75 feet away.More frequent are planting the pole more power. Posts farthest allows greater flexibility of fencing, if an animal runs into it. Use an auger to dig post holes.

Step 4 - Installation of cabling

Beginning from the wiring from the controller instead of the electric fence farther. Be careful around the spliced connection firmly and correctly. Links should be wrapped in insulation to reduce rust. Run the wires closest to the bottom ofFence to keep small animals effectively. Use an insulated wire 10-14 Gage as a bridge between the rows of electrified wire.

Step 5 - The final stages of assembly

After all the cables are securely installed on the fence, you should have further examination to be done on all the connections, you can attach the electric fence controller. Once everything is in order, put the fence. There should be an OK flashing light that indicates that the barrier is high.

Step 6 - Check the voltage

Use aVoltmeter to check to make sure that the entire electrified fence properly.